Most outdoor camera failures are not camera failures. They are enclosure failures: water ingress, condensation, heat build-up or a surge that travelled up the Ethernet cable.

The first decision is not which switch, but whether you need an outdoor-rated switch at all. Two valid architectures exist. One is an IP67 or NEMA-rated switch mounted at the pole, feeding cameras within a short radius. The other is a standard indoor switch in a properly ventilated IP54 or IP65 enclosure at the building, with all camera runs kept under 100 metres. The second is usually cheaper, easier to service and more reliable, because the switch sits in a controllable environment. Choose pole-mounted only when cable distance forces it.

If you do need an outdoor switch, four specifications decide the outcome.

IP rating. IP67 means dust-tight and protected against temporary immersion; IP66 against powerful water jets; IP65 against water jets at lower pressure. For pole-mounted units under an eave, IP65 or IP66 is normally sufficient. Do not accept an indoor switch in a "waterproof box" as an IP67 equivalent; condensation inside a sealed box with a heat source is the most common failure mode.

Temperature range. Look for an operating range, not a storage range, and check whether the quoted range applies with PoE fully loaded. A unit rated minus 40 to 75 degrees Celsius fanless is realistic for outdoor cabinets; a unit rated 0 to 50 is an indoor product with a marketing badge. In cold climates, check whether the switch starts reliably at minus 20 after a power cut.

Surge protection. Outdoor Ethernet runs collect induced surges from nearby lightning. Specify surge protection on the PoE ports, typically quoted as 4 kV or 6 kV common mode, and install external SPDs at the building entry for long runs. A switch that survives the first storm and dies in the second had no protection, only luck.

Power budget at temperature. PoE budgets derate as ambient rises. A 240 W budget at 25 degrees may be 180 W at 60 degrees inside a sun-exposed cabinet. Ask for the derating curve, and size the camera load against the derated figure.

Practical mounting details matter more than the datasheet. Mount with the cable glands facing down. Use the correct gland size for the cable diameter, not silicone. Leave a drip loop before the gland. Seal unused ports with the supplied caps. Do not mount the enclosure on a surface that reaches high temperatures in afternoon sun. Provide a breather valve or desiccant where condensation is likely. Ground the enclosure and any external SPD to the same earth point as the camera poles.

Serviceability is the last consideration, and the one people regret ignoring. A pole-mounted switch that requires a ladder and a Torx driver for a firmware reboot will not be rebooted. Prefer units with a reset button reachable through the cover, a status LED visible from below, and a DIN rail or bracket that allows removal without dismantling the camera cabling.

If you are planning an outdoor deployment, send us the site conditions: ambient temperature range, mounting location, camera count and maximum run length. We will confirm whether a pole-mounted switch or a protected indoor unit in an enclosure is the better architecture for that site, and quote the configuration with the derated power budget.