Choosing a PoE switch usually starts with the wrong question: how many watts does the switch have? The right starting point is the device at the far end of the cable. Once you know what the powered device needs, the standard, the port count and the power budget follow almost automatically.

The three standards you will meet in tenders today are 802.3af, 802.3at and 802.3bt. Most people know them as PoE, PoE+ and PoE++.

802.3af, commonly called plain PoE, delivers up to 15.4 W at the switch port and guarantees about 12.95 W at the device after cable loss. It is enough for a fixed dome camera, an IP phone, a wireless access point with a single radio, or a small access control reader. If your bill of materials is entirely this class of device, an af switch is still the cheapest and coolest option.

802.3at, or PoE+, raises the port to 30 W and guarantees 25.5 W at the device. This is the working standard for most modern IP cameras with pan-tilt-zoom, infrared illumination or built-in heaters, for dual-radio Wi-Fi 6 access points, and for video intercoms. When a customer says "PoE camera" in 2026, PoE+ is usually what they actually mean.

802.3bt splits into Type 3 and Type 4. Type 3 provides 60 W at the port and 51 W at the device. Type 4 provides 90 W at the port and about 71 W at the device. Both types use all four pairs of the cable, where af and at use two pairs. Typical Type 3 devices are multi-radio access points, large PTZ cameras with wipers and heaters, and PoE lighting controllers. Type 4 shows up with high-brightness PoE lighting, digital signage panels and compact edge servers.

A practical rule of thumb: 12 W or less, af is fine; 13 to 25 W, you need at; above 25 W, only bt will do. Buying an at switch for an af load is harmless but costs more. Buying an af switch for an at load is a failure waiting for the first cold night.

Two details decide whether the standard actually works in the field.

First, cable. All three standards assume a maximum channel length of 100 metres, and all three expect at least Cat5e. In practice, af and at work reliably on good Cat5e. Type 3 and Type 4 are far more sensitive: heat in the bundle rises with current, and marginal cable shows up as link dropouts or ports that refuse to power up. For bt deployments we normally recommend Cat6 or Cat6A, and we recommend keeping total bundle current in mind when many high-power ports run in the same conduit.

Second, the power budget of the switch. A 24-port at switch with a 370 W budget cannot run twenty-four 30 W ports at the same time, because 24 x 30 W would be 720 W. Vendors publish a total budget rather than per-port maximum for exactly this reason. Always check the sum of your device draw against the budget, not just the port count.

Mixed deployments are normal. A good switch for a CCTV project may be at on most ports with two bt ports reserved for the largest PTZ units. What matters is that the budget covers the sum and that the switch negotiates each port independently, which 802.3af, at and bt switches do by design.

If you are writing the specification for a tender, state three numbers for each device class: the standard, the power the device draws in its worst case, and the total quantity. Those three numbers let any supplier size the switch correctly and let you compare quotations on equal terms.

If you are not sure which class your camera or access point belongs to, send us the datasheet or the model number. We will tell you the standard, the worst-case draw and the recommended switch configuration, and quote the port mix that actually fits the project.