Start with the exact devices

List each camera or access point by model, quantity and documented maximum input demand. Use the device datasheet rather than a typical operating figure. Record whether heaters, infrared lighting or accessories change the requirement. A camera count alone is not a power specification.

Make the arithmetic explicit

For an illustrative worksheet, eight devices listed at 7 W and two listed at 13 W total 82 W of stated endpoint demand: 8 × 7 + 2 × 13 = 82. These are hypothetical values, not specifications for any product on this site. The result is an input to the design review; it does not account for every cable loss, power allocation rule or reserve requirement.

Check the switch budget and each port

Ask for the usable PoE budget of the complete switch configuration, the supported PoE type and the per-port allocation rules. A power-supply label describes the supply component and should not be substituted for the finished switch PoE budget. The selected endpoint must also be compatible with its individual port; a sufficient total alone does not prove compatibility.

Review the complete project before ordering

Send the worksheet with cable routes, simultaneous operating conditions, expansion plans and upstream equipment. Ask the supplier to confirm the model-specific power budget in writing. Include the maximum device demand in sample validation, then retain the approved configuration with the purchase order.

Related product families

Technical references